Join PrimeGrid
Returning Participants
Community
Leader Boards
Results
Other
drummers-lowrise
|
1)
Message boards :
Generalized Fermat Prime Search :
GFN Extreme error
(Message 142134)
Posted 1040 days ago by [H]auntjemima
Same issue. I am running the latest drivers. I will try and older version later.
|
2)
Message boards :
Generalized Fermat Prime Search :
GFN Extreme error
(Message 142131)
Posted 1040 days ago by [H]auntjemima
Windows updates periodically (no make that regularly) disturb the drivers. Downloads the Nvidia drivers from Nvidia directly, install and try again.
Thanks for the replies guys! I only download my updates from Nvidia directly AND I don't run windows updates.
BUT! I will remove and reinstall the drivers. Can't hurt.
|
3)
Message boards :
Generalized Fermat Prime Search :
GFN Extreme error
(Message 142127)
Posted 1040 days ago by [H]auntjemima
Hey guys! First post here, but I have done some PG work in the past. Recently I got a 1080gtx and I have been wondering what I should run it on! Well, I decided on the extreme, just to see.
But I noticed the first two tasks failed in a few seconds. The ended with..
Stderr output
<core_client_version>7.12.1</core_client_version>
<![CDATA[
<message>
The storage control blocks were destroyed.
(0x7) - exit code 7 (0x7)</message>
<stderr_txt>
geneferocl 3.3.3-2 (Windows/OpenCL/32-bit)
Copyright 2001-2018, Yves Gallot
Copyright 2009, Mark Rodenkirch, David Underbakke
Copyright 2010-2012, Shoichiro Yamada, Ken Brazier
Copyright 2011-2014, Michael Goetz, Ronald Schneider
Copyright 2011-2018, Iain Bethune
Genefer is free source code, under the MIT license.
No NVIDIA compatible OpenCL device found.
13:40:36 (6024): called boinc_finish(7)
</stderr_txt>
]]>
I see the error SEEMS like an OpenCL error, but I have run this card on other opencl projects without issue and gpuz says I have opencl. Thoughts?
|
4)
Message boards :
Number crunching :
GFN21 tasks times
(Message 135935)
Posted 1258 days ago by [H]auntjemima
Thanks guys! These cards are running around 60C on PG. I would rule out the power supply issue as the culprit simply because it runs milkyway tasks with no change. It might have just been a one off task, so I aborted it.
|
5)
Message boards :
Number crunching :
GFN21 tasks times
(Message 135898)
Posted 1259 days ago by [H]auntjemima
Hey guys, I have been running GFN21 tasks during the recent challenge and was just getting ready to finish up my tasks and noticed something. One of my tasks has been running fr 7 days, it at about 44% and has 9 days left (estimated).
All other cards on the system are identical (7950's) and take about 22 hours. I rarely check these systems, just set it and forget it, so I was surprised. Its not an Extreme task, just a standard task.
Anyone seen this before?
|
|
